NEC Univerge SV9100 - Page 233

Issue 4.0
SV9100 Programming Manual 2-193
69
Microphone Operation on
Handsfree
Select the microphone status when
starting Handsfree mode.
0 = No change for MIC status
1 = Start from MIC enabled
2 = Start from MIC muted
0
70
MIC Key Operation
Control whether the microphone
key is enabled (0) or disabled (1).
0 = Enabled
1 = Disabled
0
71
Disable Softkey
When set to 1 (On), disable Softkey
and cursor key operation at the
terminal.
0 = Off
1 = On
0
72
Large LED Illumination Setup
Internal Incoming)
2 = Red
3 = Green
4 = Blue
5 = Yellow
6 = Purple
7 = Light Blue
8 = White
9 = Rotation
3
73
Multiline Telephone Basic Data
Setup - Calling Party History
View Mode
For saving multiple entries for the
same number (in case of different
calling times), set this to 1. For
saving a single entry for the same
number, set this to 0.
0 = Pack
1 = Unpack
0
74
Ten Key Backlit Control
This program sets the brightness of
the ten key backlighting
When Set to Normal (0), brightness
of ten key backlighting is Full.
When set to Half (1), brightness of
ten key backlighting is Half.
0 = Normal
1 = Half
0
Table 2-4 Lamp Cycle On/Off Timing Pattern
Programs 15-02-35, 36, and 38
Input Cycle
1 Cycle 1 500ms – ON / 500ms – OFF
2 Cycle 2 250ms – ON / 250ms – OFF
3 Cycle 3 125ms – ON / 125ms – OFF
Item
No.
Item Input Data Default
Related
Program