NEC Univerge SV9100 - Page 370

Issue 4.0
2-330 Program 21 : Outgoing Call Setup
05
Disconnect Time when Dial Tone
not Detected
If 14-02-11 is enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to calls
placed using Speed Dial, ARS, Last
Number Redial or Save Number
dialed. It does not pertain to line key
or Direct Trunk Access calls.
0~64800 (sec)
3
06
Dial Pause at First Digit
0~64800 (sec)
1
07
Toll Restriction Override Time
After dialing the Toll Restriction
Override codes, the system removes
Toll Restriction from the extension for
this time.
0~64800 (sec)
10 20-08-06
21-07
08
Preset Dial Display Hold Time
0~64800 (sec)
10
09
Ringdown Extension Timer (Hotline
Start)
A Ringdown extension automatically
calls its programmed destination after
this time.
0~64800 (sec)
5 20-08-09
21-11
10
Dial Digits for Toll Restriction Path
If this option is programmed with an
entry other than 0, a call does not
have a talk path unless the user dials
at least the number of digits entered in
this option when placing an outgoing
call.
This means that an entry of 4 or
higher in this program causes a
problem when dialing 911(USA only).
Since it is only a 3-digit number, the
call does not have a talk path,
preventing the emergency dispatcher
from hearing the caller. This option
should be kept at its default setting of
0 to prevent any problems with dialing
911 (USA only).
0~24
0
11
Inter-Digit Time for Toll Restriction
Path Control
0~60
0
Input Data (Continued)
Item
No.
Item Input Data Default
Related
Program