NEC Univerge SV9100 - Page 377

Issue 4.0
SV9100 Programming Manual 2-337
07
Permit Code Table
1~4 = Table
0 = Disable
(None)
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
Set the tables 1~4 when
referring to the table set up by
21-06-06.
21-06-06
08
Restriction Table
1~4 = Table
0 = Disable
(None)
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
Set the tables 1~4 when
referring to the table set up by
21-06-07.
21-06-07
09
Restriction for
Common Speed Dials
0 = Does Not
Restrict
1 = Following
Restriction
Check
0
Enable/Disable Toll Restriction
for Common Speed Dialing
numbers. If enabled, System
Speed Dialing numbers have the
same restrictions as manually
dialed numbers.
10
Restriction for Group
Speed Dials
0 = Does Not
Restrict
1 = Following
Restriction
Check
0
Enable/Disable Toll Restriction
for Group Speed Dialing
numbers. If enabled, Group
Speed Dialing numbers have the
same restrictions as manually
dialed numbers.
11
Intercom Call
Restriction
0 = Disable (No)
1 = Enable (Yes)
0
Determine if incoming intercom
calls are restricted.
12
PBX Call Restriction
0 = Disable (No)
1 = Enable (Yes)
1~6, 8~15 = 0
7 = 1
Set how the system Toll
Restricts calls over PBX trunks.
If you enable PBX Toll
Restriction, the system begins
Toll Restriction after the PBX
access code. The user cannot
dial a PBX extension. If you
disable PBX Toll Restriction, the
system only restricts calls that
contain the PBX access code.
The system does not restrict
calls to PBX extensions. Refer to
the PBX compatibility feature.
Make sure Program 21-05-04
(Maximum Number of Digits
Table Assignment) allows for
PBX Toll Call Dialing (normally
12 digits).
13
Restriction of Tie
Line Calls
0 = Disable (No)
1 = Enable (Yes)
0
Enable/Disable the toll restriction
of the dial set up by 34-08.
34-08
Item
No.
Item Input Data Default Description
Related
Program