NEC Univerge SV9100 - Page 613

Issue 4.0
SV9100 Programming Manual 2-573
07
Digital Pager Callback Number
(Pager CBack)
Set the Digital Pager Callback Number portion
of the Message Notification callout number for
a digital pager. This is the portion of the callout
number that is appended to the pager service
telephone number. Normally, this option should
be XM
#, where:
 X is the number of the extension that
generated the notification.
  is a visual delimiter (to make the pager
display easier to read).
 M is the number of new messages in the
extension mailbox.
 # is the digit normally used by the pager
service for positive disconnect.
Digits
(12 maximum, using 0~9,
# and
)
M (Number of messages –
entered by pressing LK1)
X (Extension number – entered
by pressing LK2)
SV8100 InMail automatically
replaces the X command with
the number of the extension
that initially received the
message.
X
M#
08
Delay in Dialing Digital Pager Callback
Number
(Pager Dial Delay)
Set the delay that occurs just before SV8100
InMail dials the Digital Pager Callback Number
portion of the Message Notification callout
number for a digital pager. Set this delay so the
pager service has enough time to connect to
the digital pager before sending the callback
number. Your pager service may be able to
help you determine the best value for this
option. When placing a digital pager
notification, the system:
Seizes the trunk specified.
Dials the user-entered notification number (in
Message + OP + N).
Waits the 47-01-08: Delay in Dialing Digital
Pager Callback Number interval.
Dials the number entered in 47-01-07: Digital
Pager Callback Number.
The system assumes that the notification
number completes dialing approximately 4
seconds after trunk seizure. This means that,
by default, the Digital Pager Callback Number
is dialed into the pager service about 13
seconds after trunk seizure.
0~99 (sec) 30
Input Data (Continued)
Item
No.
Item Input Data Default