NEC Univerge SV9100 - Page 618

Issue 4.0
2-578 Program 47 : InMail
04
Message Playback Order
Set the Subscriber Mailbox message playback
order. When a subscriber listens to their messages,
SV8100 InMail can play the oldest messages first, or
the newest messages first.
0 = FIFO (first-in/first-out,
or oldest messages first).
1 = LIFO (last-in/first-out,
or newest messages first)
0
05
Auto Erase/Save of Messages
Determine what happens when a Subscriber
Mailbox user completely listens to a new message
and then exits the mailbox without either saving (SA)
or erasing (E) the message. Depending on the
setting of this option, SV8100 InMail either
automatically saves or erases the message. If the
mailbox user hangs up before listening to the entire
new message, SV8100 InMail retains the message
as a new message.
0 = Erase
After the subscriber listens
to the entire new message
and hangs up, SV8100
InMail erases the
message.
1 = Save
After the subscriber listens
to the entire new message
and hangs up, SV8100
InMail saves the message.
1
06
Message Retention
Determine how long a Subscriber Mailbox retains
held and saved messages. If a message is left in a
Subscriber Mailbox longer than this interval, SV8100
InMail deletes it.
1~99 Days
0 = Indefinite
0
07
Recording Conversation Beep
(Rec Conv Beep)
Enable/Disable the Conversation Record beep. If
enabled, all parties on a call hear the voice prompt
“Recording”, followed by a single beep when the
extension user initiates Conversation Record. If
disabled, the voice prompt and beep do not occur.
When you disable the Conversation Record beep,
the following voice prompts do not occur while
SV8100 InMail records the conversation:
Recording
(followed by a beep)
That mailbox is full
(if the mailbox message storage capacity is reached)
You have reached the recording limit
(if the recorded message is too long)
The UNIVERGE SV9100 telephone system software
provides an additional Conversation Record beep.
This beep repeats according to the setting of
Program 45-01-06: Voice Mail Integration
Options: Record Alert Tone Interval Time
(0~64800 seconds). To disable the UNIVERGE
SV9100 telephone system Conversation Record
beep, enter 0 for this option.
0 = No (Disable)
1 = Yes (Enable)
1
Item
No.
Item Input Data Default