NEC Univerge SV9100 - Page 875

Issue 4.0
SV9100 Programming Manual 2-835
Conditions
 The entire terminal that has an Alarm Display setting can be set at PRG90-50-01.
 System Alarm Type is shown despite the setting done at 90-10-01. If multiple Alarm Display Setting is
set, only one highest priority alarm will be shown on a LCD Display.
 The priority level (highest -> lowest): Alarm 55 > Alarm 7 > Alarm 5 > Alarm 30 > Alarm 8 > Alarm 52>
Alarm 29 > Free Demo License Period.
91 2 0 Primary auto-
integration.
Primary auto-integration
function operated.
Primary auto-
integration function
operated.
No action is necessary. INF
92 2 0 Primary
compulsion
specification.
The Primary compulsion
specification function was
executed.
Primary
compulsion
specification
function was
executed.
No action is necessary. INF
93 2 0 NetLink node
connection
detection.
Node connection with
NetLink Primary was
detected.
Node connection
with NetLink
Primary was
detected.
No action is necessary. INF
94 2 0 NetLink node
secession
detection.
Secession of the node
detected with NetLink
Primary.
Secession of the
node detected with
NetLink Primary.
No action is necessary. INF
95 2 0 Data Base
replication
failure.
Because Secondary is in
programming mode, the
replication of DB cannot be
executed.
Logging in with
Secondary in the
Web Pro or the PC
Pro is possibly the
cause.
Log out from Secondary
programming mode.
WAR
96 1 0 Data base
recovery fail.
Error happened when
DataBase recovery
operation.
Backup/Restore
Lack of resource
Memory, protected
area, recovery data
file corruption are
possible reasons
for this.
Delete unnecessary file
and restore open area,
then try operation
again.
WAR
97 2 0 DB recovery
operation
start.
Start Data base recovery
operation.
Backup/Restore/Delete
Start Data base
recovery operation.
No action is necessary. INF
98 2 0 DB recovery
operation
finish.
Finish Data Base recovery
operation.
Backup/Restore/Delete
Finish Data base
recovery operation.
No action is necessary. INF
99 1 0 NetLink
configuration
error.
The error occurs when the
system tries to start
NetLink without MEMDB.
PRG51-01-01 is set
without PZ-ME50
US.
Install PZ-ME50 US. WAR
100 1 0 NetLink link
error.
This alarm occurs when
the primary system cannot
communicate with
secondary system.
Primary system
cannot
communicate with
Secondary system
because of
Network error.
Primary system cannot
communicate with
Secondary system
because of Network
error.
WAR
Alarm
No.
Type Report Name Content of Alarm Cause Action Recovery
Alarm
Status