NEC Univerge SV9100 - Page 89

Issue 4.0
SV9100 Programming Manual 2-49
Conditions
None
Feature Cross Reference
None
06
IP Trunk Port Binding
Trunk port binding is
only used for SIP trunks
to the provider in Non-
Registration Mode only.
When this is disabled,
an inbound call comes
in and follows your DID
routing but it comes in
on the first available
trunk. When enabled,
the inbound call comes
in and follows your
normal DID routing but
maps to that specified
trunk. If that trunk is
busy, it sends back a
busy unless you build a
hunt group. To build the
hunt group, it
references command
14-12-02 (pilot register
ID). This points you to
command 10-36-02. All
numbers with the same
pilot are in the same
hunt group.
0 = Disable
1 = Enable
0
Input Data (Continued)
Item
No.
Item Input Data Default
Profile
1~6