SV9100 Programming Manual 2-891
Program: 92
Description
Use Program 92-01 : Copy Program to copy the data for one program to another multiline terminal,
port, group, or other number. Refer to the following charts to see which programs can be copied. .
Program 92 : Copy Program
92-01 : Copy Program
Level:
IN
This program is available only via telephone programming and not through PC
Programming.
Input Data
Program Number XX-XX
Item
No.
Item Input Data
01
Source Number
Enter the extension, trunk, group or other
number from which the data is to be
copied.
For Trunk Base :
Trunk Port Number 1~400
For Trunk Group Base :
Trunk Group Number 1~100
For Extension Base :
Extension Number (up to eight digits)
For Department Group Base :
Department Group Number 1~64
For DSS :
DSS Console Number 1~32
Destination Number (From)
Enter the first extension, trunk, group or
other number to which the information is
to be copied.
Destination Number (To)
Enter the last extension, trunk, group or
other number to which the information is
to be copied. If the information is being
copied only to one extension, trunk, group
or other number, enter the information
entered in the Destination Number (From)
entry.
To Next Page
Loading...
