Siemens SINAMICS G220 - Page 569

- 2503 -
1
Internal control/status words Status word, sequence control
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
Reserved
Bit No. Meaning
r0899 r0899.0..13
Status word sequence control
r0899.31 = Jog active r0899.41 = No coasting active OFF2 inactive r0899.51 = No Quick Stop active OFF3 inactive r0899.61 = Switching on inhibited active r0899.71 = Drive ready r0899.81 = Controller enable r0899.91 = Control request r0899.111 = Pulses enabled r0899.121 = Open holding brake r0899.131 = Command close holding brake
01 00 02 03 05 06 07 08 10 11 12 14 13 04 09 15
Reserved Reserved
PROFIdrive-Bit
<1> The drive is ready to accept data.
r0899.21 = Operation enabled r0899.11 = Ready r0899.01 = Ready for switching on
[2510.2], [2701.1] [2510.2], [2701.1] [2510.2] [2510.2] [2510.2] [2510.2] [2510.2] [2510.2]
≥1
&
c0845 [C]
(1)
No coast-down / coast-down
(OFF2) signal 2
c0849 [C]
(1)
No Quick Stop / Quick Stop
(OFF3) signal 2
OFF1 OFF2 OFF3
<1>
Enable internal missing or fault with this reaction
Bit 9 = 1 --> Ready to exchange process data
[2701.8] [2701.8]
[2610] [2610] [2610] [2610] [2610] [2610] [2610] [2610] [2610]
c0864
(13863.0)
Infeed
operation
Only for Clean Power infeed.
Figure14-164 2503 - Status word sequence control
Functions
14.11Drive functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 567