Siemens SINAMICS G220 - Page 653

- 2536 -
1
Internal control/status words Status word, monitoring functions 2
© Siemens AG
2 3 4 5 6 7 8
V6.02.00
Bit No. Meaning
r2198 r2198.0..13
Status word monitoring 2
r2198.31 = |n_act| > speed threshold value 6 r2198.41 = |n_set| < p2161 r2198.51 = n_set > 0 r2198.61 = Motor blocked r2198.71 = Motor stalled r2198.81 = |I_act| < I_threshold value p2170 r2198.91 = |M_act| > torque threshold value 1 and n_set reached r2198.101 = |M_set| < torque threshold value 1 r2198.121 = Load in the fault range
01 00 02 03 05 06 07 08 10 11 12 14 13 04 09 15
r2198.01 = |n_act| <= speed threshold value 5 r2198.11 = |n_act| > speed threshold value 5 r2198.21 = |n_act| <= speed threshold value 6 r2198.131 = |M_act| > torque threshold value 1 r2198.111 = Load in the alarm range
Reserved Reserved
[8023.8] [8023.8] [8023.8] [8011.8] [8011.8] [8015.8] [8015.8] [8022.8] [8023.8] [8012.8] [8013.8] [8013.8] [8023.8] [8023.8]
Figure14-221 2536 - Status word monitoring functions 2
Functions
14.11Drive functions
SINAMICS G220 converter
Operating Instructions, 04/2024, FW V6.2, A5E51781573B AB 651