Phaser 6180MFP Multifunction Printer Service Manual 4-15
General Troubleshooting
MAC+PHY Test MAC+PHY Test
■ Start
■ Processing
■ Check OK
■ MAC+PHY ERROR
Tests PHY Internal loopback test.
Note: Run this test when errors 016-
334, 016-340, 016-344, 016-345, 016-
346, and 016-347 occur.
ASIC Test ASIC Test
■ Start
■ Check OK
■ ASIC ERROR
Performs register test.
Note: Run this test when error 116-343
occurs.
Engine Test Engine Test
■ Start
■ Check OK
■ Engine ERROR
Performs communication test with the
Engine Controller. Then it reads the
status register of the engine to check
whether commands can be exchanged
with the engine.
Note: Run this test when error 016-370
occurs.
Engine Diag Performs function checks on the components whether they
operate normally or not.
Note: During Engine Diag test, other Service Diagnostics functions
cannot be performed simultaneously.
Sensor Test Tests the sensors and switches of the
printer.
When a paper jam is occurred, or an
error message or code is displayed,
run this test to locate the damage
components.
Note: The Low/High values can be 0 to
99, and they can be incremented as the
sensor state changes. This value is
incremented up when a sensor or
switch is turned On from Off, which
allows the user to know the component
is active.
Duplex Jam
Sensor
Duplex JamSensor
■ OFF
■ L - 0
■ H - 0
Tests the Duplex Jam Sensor.
Exit Sensor Exit Sensor
■ OFF
■ L - 0
■ H - 0
Tests the Exit Sensor.
Regi Sensor Regi Sensor
■ OFF
■ L - 0
■ H - 0
Tests the Registration Sensor.
Printer Diag Test Table (continued)
Test Control Panel Display Test Description
To Next Page
Loading...
