7. Load 100–500 sheets of paper, then align the paper edges in the direction shown (1). For preprinted media,
load the paper with the printed side facing up. Hold the side guides by its grip, then move them to touch the
long edges of the paper lightly (2).
Note: Ensure that you load the paper in the short-edge-feed (SEF) direction. The right side of the short edge
of the postcard is the leading edge (1).
8. Load the remaining sheets in the tray.
a. Align the paper edges in the direction shown (1).
b. Move the end guide to touch the short-edges of the paper lightly (2).
Adjust the paper guides by pressing in the guide release lever and carefully moving the guides until they
touch the edges of the paper lightly.
9. Gently push the tray into the press until it comes to a stop.
10. To remove and store the postcard guides, perform the following:
a. Remove any paper from the tray.
b. Unfasten the screw from the postcard guide.
Xerox
®
Versant
®
280 Press User Documentation 155
Working With
To Next Page
Loading...
Need help?
General
