4. Load one envelope with the paper edges aligned in the direction shown (1), to place it on parts E and F. For
preprinted media, load the paper with the printed side facing up. Hold the end guide by its grip, then move it so
that it touches the edges of the envelope lightly (2). Adjust the paper guides as needed.
Note: Do not press the paper guide forcefully or leave a gap between the end guide and the envelope.
These actions can cause a paper feeding error.
5. To fill the tray easily, load the stack of envelopes in small bundles. Bend the envelope stacks to provide
additional clearance while loading.
6. Load each stack of envelopes and align the envelopes edges in the direction shown (1). Hold the side guide by
its grip, then move it to touch the edges of the envelopes lightly (2).
7. When you load envelopes repeatedly, widen the side guide, then repeat the loading process for every bundle of
about 100 envelopes. When you are using the Postcard Kit, align the envelopes by putting your hand between
the side guide and the envelopes.
Note: If the envelopes do not align, misalignment on prints or a paper feed error can occur.
LLooaaddiinngg EEnnvveellooppeess WWiitthhoouutt tthhee LLaarrggee EEnnvveellooppee KKiitt
1. Pull out the tray toward you until it stops.
Xerox
®
Versant
®
280 Press User Documentation 161
Working With
To Next Page
Loading...
