9. Replace a new separator roll into the black notches of the assembly using the same technique.
10. Reinstall the separator assembly into the tray. Align the cutout holes of the assembly with the frame of the tray
so the pin holes match up. Insert the assembly into the frame. Slide the assembly all the way to the right using
the pin as a guideline. Ensure the device is all the way into the slots and the 3 screw areas align.
11. Screw in the 3 thumbscrews to attach the assembly. Do not over tighten.
12. Close the tray and verify that the tray is operating successfully by feeding paper using that tray.
13. Log in as the administrator or ask the administrator to perform the following steps to reset the High Frequency
Service Item (HFSI) count to zero (0).
a. At the Control Panel, press the Machine Status button.
b. Select the Tools tab.
c. Select System Settings > Common Service Settings > Maintenance.
d. Use the arrow buttons to access the next Maintenance screens.
e. Select the Technical Key Operator (TKO) icon.
The Technical Key Operator feature displays.
f. Log in to the Technical Key Operator mode.
AAtttteennttiioonn
If you cannot log in as T
g. Select the item that corresponds with the newly-replaced components.
h. Select Reset Current Value. The system resets the High Frequency Service Item (HFSI) to 0.
254
Xerox
®
Versant
®
280 Press User Documentation
Working With
To Next Page
Loading...
