6. Slide the separator assembly all the way to the left so it is out of the slots. Pull the assembly out towards you
until completely removed from the tray. Set aside.
7. With the separator assembly out, access and remove the feed roll. To remove, squeeze both ends of the metal
shaft and lift out. To replace, squeeze both ends of the new roll shaft, and insert and release the roll ends into
the notches.
8. Finally, replace the separator roll. Squeeze the orange shafts of the separator roll and lift out of the assembly.
Xerox
®
Versant
®
280 Press User Documentation 253
Working With
To Next Page
Loading...
