Installation & Operation Manual 786 Document # LTRT-92224
Mediant 8000
Note: The Media Gateway software on both SC boards must be stopped (via the
tools sc dn command) prior to proceeding to the next step. If you attempt to restore
the backup file on the Standby SC board, while the Active SC is still operating, the
restored configuration database will be erased by the replication mechanism.
4. On the SC board in Slot 1 (designated to be Active board), change the current
directory to the place where the backup file is stored (typically, the home
directory of the CLI user that you used to perform the file transfer) and type the
following commands to start the restore process:
client238::~# cd /data/acladmin
client238::~# chmod u+x backup_12jan2009.bk
client238::~# ./backup_12jan2009.bk
RESTORE
This backup contains the following data:
Product type : Mediant 8000
Software version : 6.6.15
Binaries included : Yes
Created at : Sun Jan 12 18:20:10 2009
Created on : 10.7.9.245
IMPORTANT: Prior to restoring the backup, run 'tools sc dn' command on
BOTH SC boards to make sure that Media Gateway software is stopped on
both SC boards.
5. When prompted to confirm the restore operation, type y and press Enter. The
restore process begins.
Restore? ([y]/n) : y
Please wait patiently until restore completes.
The process may take up to 10 minutes.
Extracting backup data... done
Uncompressing backup data... done
Uninstalling current SC software... done
Installing backup data... done
Repairing installation... done
Media Gateway software was successfully restored from the backup.
6. When the restore completes, you will be prompted to reboot the SC board. Type
y at the prompt and press Enter.
To Next Page
Loading...
