436
Magellan™ 9800i Scanner
GS1 DataBar Omnidirectional
• Prefix must be ASCII characters ‘]e0’
• Check character must be included in label
• Application identifier “01” must follow the prefix and precede the base label
• Label length excluding prefix characters must be 16 characters.
• Example: ‘]e00101044123456789’
GS1 DataBar Expanded
• Prefix must be ASCII characters ‘]e0’
• Label length excluding prefix characters must be at least 1 character. Maximum length
is the maximum label size supported by the scanner.
• The format of the label must not be of the same format as RSS-14 (application id &
length equal to 16)
• Example: ‘]e002900123456789083103001750’
Interleaved 2 of 5 (I 2 of 5)
• Check character must be included in label data
• Label length including check characters and excluding prefix characters must meet
requirements imposed by the main scanner’s fixed or variable label length control for
this symbology type.
• Prefix must be an ASCII character ‘]I1’ (other prefixes specify different check charac-
ter properties which are not supported).
• Example: ‘]I10123456789’
Code 128 / EAN 128
• Prefix must be either ASCII characters ‘]C0’, ‘]C1’ or ‘]C2’
• Label length excluding prefix character must meet requirements imposed by the main
scanner’s fixed or variable label length control for this symbology type.
• If CI_EAN128_ENABLED is TRUE and prefix is ‘]C1’, label will be identified as an
EAN128 otherwise it is identified as a Code 128.
• A prefix of ‘]C0’ designates that no function code is present in the 1st or 2nd character
position
• A prefix of ‘]C2’ designates that a function code 1 is present in the 2nd character.
• Example : ‘]C0Code_128.Test’
Standard 2 of 5 (S 2 of 5)
• Prefix must be ASCII characters ‘]S0’
• Label length excluding prefix characters must meet requirements imposed by the main
scanner’s fixed or variable label length control for this symbology type.
• Example : ‘]S01234567890’
To Next Page
Loading...
