Merging Pyramix - Track Tab Column Fields; Making Settings Changes to Multiple Tracks; Changing Repro or Input Connections; Repro Connection

Tracks and Track Groups : Tracks Tab Window
5 - 104
Making Settings Changes to Multiple Tracks
Changes to Tracks settings can be made on a multiple selection of Tracks. Press Ctrl and Click on a Track to add or
subtract it or press
Shift to select a contiguous range of Tracks.
Changing Repro or Input connections
Clicking in the column field to drops down a list of available connections. Highlight the required connection to
select it.
With a range of Tracks selected, choosing a connection from the list assigns all selected Tracks to the same con-
nection. If
Alt is held down while choosing the selected Tracks are connected in ascending order.
Track Tab Column Fields
Name
The name of the Track. Up to 29 characters are visible in this field but longer names are accepted. Click in the field
or use
F2 to enter a new name.
Repro Connection
Shows which Mixer Input Strip (and Channel if applicable) the Track is connected to. Clicking in this column field
drops down a list box with all available Mixer Input strips (and Channels). Strip number on the left followed by
Channel Tag with the Strip Name in brackets.
Input Connection
Shows which Input is feeding the Track. Clicking in this column field drops down a list box with all available physi-
cal inputs and Internal Return buses.
Group
Shows which Track Group (if any) the Track belongs to. (see below) Clicking in this column field drops down a list
box with all available Track Groups.
Solo
If YES Track is soloed.Clicking in this column field toggles between YES and blank.
Mute
If YES Track is muted.Clicking in this column field toggles between YES and blank.
Record Ready
Shows the current record ready state. Clicking in this column field drops down a list box with the three possible
states,
Safe, Record Ready and Auto-Punch.
Monitoring
Shows the current monitor mode. Clicking in this column field drops down a list box with the three possible
modes,
Auto, Input and Repro.
Hidden
If YES the Track is not visible in the Timeline but continues to operate normally. Clicking in this column field tog-
gles between
YES and blank.
Always Visible
If YES the Track will always appear on screen (if there is sufficient room) even when scrolling other Tracks.
Collapsed
If YES the Track is a member of a Track Group currently collapsed. (see below)
Display Mode
Shows the current Clip Display Mode mode. Clicking in this column field drops down a list box with the three pos-
sible modes,
Block, Waveform or Envelope