Remote Control : EMC
23 - 518
EMC
Scope
EMC includes HUI and Mackie Control Support.
The following controllers are supported and validated:
• Mackie MCU in HUI and MackieControl modes
• Yamaha DM1000 in HUI mode
• Yamaha DM2000 in HUI mode
• Raditec SAC2-k in HUI mode (MackieControl is not working properly)
• Tascam US-2400 in HUI mode (US-2400 MackieControl mode is specifically configured for other DAWs
than Pyramix)
Key
Valid Remote Control Support and Remote Control – Midi Enhanced Midi protocol keys are required to use EMC.
Configuration
Configuring a Remote EMC Connection
Since EMC is implemented as a subset of OASIS, to configure a remote connection, an OASIS controller must be
added in
Settings > All Settings > Remote Control and then EMC must be chosen by clicking the Properties
button which opens the
OASIS Configuration dialog:
Faders, Solo, Mute, Pan, Surround Panning, Auxes, Vu-Meter, Advance channel display, Strip tools,
transport (Internal and Externals machines), Bank switching and Jog are all fully supported. Please see the
EMC
User Guide
for full configuration details.
To Next Page
Loading...
