Mixer : Mix !
10 - 210
Rearranging Strips
Input strips and VCA group Strips can be re-ordered in the Configure page. Input strips, VCA group strips and Sub-
group strips can also be moved directly in the console UI.
Only Input Strips, Groups and SubGroups can be moved. The Bus Masters Strips cannot.
Using Context Menu:
• Select one or more Strips
• In the right-click context menu choose
Strip > Copy Selected Strips
• Select a destination Strip <x>
• In the right-click context menu choose
Strip > Paste Copied Strips Before <x> or Paste Copied Strips
After <x>
Using Drag & Drop:
• Select one or more Strips
•Press
Ctrl + Shift + Alt
• Drag the selected Strips onto any other Strips
Note: If a Sub-group or VCA group is not moved, i.e. located at the far right of all the input strips,
it is locked in place when scrolling the input strips. When a Sub-group or VCA group is moved in
between other input strips it is then scrolled with them.
Multiple Strip Selection and Operations
Multiple Console Strips can be selected together.
Select Multiple Strips
Click on a Strip then press and hold the Ctrl key and click on the Strip number (below the fader) to add or remove
other strips to or from the selection.
Click on a Strip then press and hold
Shift and click on another Strip number (below the fader) to select all Strips
between the first selected and the last.
To cancel the multiple selection click on a Strip
number (below the fader) on any of the selected strips.
Linked Actions on Multiple Selected Strips
Press and hold [Ctrl] + [Shift] to perform any of the following on all selected (highlighted) strips:
• Double-click on any of the Faders, Gain Knobs or Pans in the selected strips to reset all of them to the
default value.
• Move Faders or Gain Knobs in any of the selected Strips moves all of the faders or knobs in the selected
strips while preserving their delta.
• Click on any button, e.g. On/Off, Mute, Solo, IP, Phase, Record Ready, etc… to set the same state on all the
selected strips.
• Add or subtract all selected Strips to or from a VCA group. (When subtracting the
Leaving VCA Group
dialog appears for each Strip which is assigned to the VCA Group.)
• Adding Effects (Support for VS3 effects)
• Copying Effects (Support for VS3 effects)
•Stem change
Note: If [Shift] only is pressed and held the above actions are performed on ALL Strips regard-
less of any selections.
Note: On a MultiBus Matrix router if [Control] + [Alt] are pressed and held then the patching is
performed on the selected Strips by incrementing the patched slot for each Strip.
To Next Page
Loading...
