Automation : Automation Settings
15 - 385
Note: When pan information from a mono strip is applies to a stereo surround panner only the
left-hand channel is affected.
Note: When pan information from a stereo strip is applied to a mono surround panner only the
Left information is used.
Automation Settings
Select All Settings > Application > Automation. (Automation > Automation Settings also takes you to the
Automation page).
Optimizations
Offers a choice of options to enhance system performance when using automation.
Keep only current version while saving when checked, the system only saves the current version of all automa-
tion Tracks. This looses the saved automation versions history, but dramatically shortens the save time for projects
with automation.
Limit versions to the number of Undo/Redo when checked the system only keeps a limited number of versions
in memory (the same as the number of
Undo/Redos as defined in the Settings > All Settings > General Page).
This reduces the number of automation versions kept in the history but enhances performance.
Auto-Release Options
If Auto Release is enabled any control will, when released or when the transport is stopped, return to its value or
state in the previous automation pass or the default where no previous pass exists. This occurs either immediately
if the control only has two states (e.g. a button) or over a period of time if the control is a fader or knob. The time
period is determined by the value entered in the
Release Time box in ms.
Refresh Rate
The Refresh Rate setting determines the rate at which the automation data is recorded. By default the refresh rate
is the same as the actual time code frame rate, e.g. 40 ms at a frame rate of 25 fps.
To Next Page
Loading...
