Merging Pyramix - 2,3 and 4 Point Edits

Editing : Source - Destination Editing
8 - 190
The menu item:
Edit > Source - Destination Settings > Auto Set Destination Gate In after Edit
allows the Destination Gate In to be set to the previous Destination Out point after any Source-Destination opera-
tion. This automatically prepares the Destination for the next operation. The Destination is also automatically cen-
tered around the new Gate In.
The menu item
Edit > Source - Destination Settings > Auto Set Destination Gate In after Edit allows the Desti-
nation Track Group to be automatically selected after any Source-Destination operation.
All these operations works independently of the
Auto-Ripple mode (they have their own overwrite/ripple modes
described in the table on the next page) but follow the Auto-Crossfade settings accessible in the menu
Edit >
Auto-Crossfade
.
Keyboard Shortcuts
Most Source - Destination operations are available as Keyboard Shortcuts.
2,3 and 4 Point Edits
Source-Destination
operations
Source
Gate In OR Gate Out Only
Source
Gate In & Gate Out
Destination
Gate In OR Gate Out Only
Auto-Edit:
Performs 2 points edit-
ing by doing the following
Over-
write
operation.
Overwrite: Copies material FROM
Source Gate In to the end of the
Track or from start of Track to Gate
Out
TO Destination Gate In or Destina-
tion Gate Out by overwriting Desti-
nation material
Auto-Edit: Performs 3 point editing by doing
the following Overwrite or Insert operation
depending which one is selected in the menu
Edit > Source-Destination Settings.
Overwrite: Copies material between Source
Gate In and Source Gate Out to Destination
Gate In or Destination Gate Out by overwrit-
ing Destination material
Insert: Copies material between Source Gate
In and Source Gate Out to Destination Gate In
or Destination Gate Out by rippling Destina-
tion material
Destination
Gate In & Gate Out
Auto-Edit: Performs 3 points edit-
ing by doing the following
Over-
write
operation.
Overwrite: Copies material from
Source Gate In or Source Gate Out
to Destination Gate In and Gate
Out by overwriting Destination
material
Auto-Edit: Performs 4 point editing by doing
the following
Replace operation.
Overwrite: Copies material between Source
Gate In and Source Gate Out to Destination
Gate In by overwriting Destination material.
Insert: Copies material between Source Gate
In and Source Gate Out to Destination gate In
by rippling Destination material
Replace: Replaces material between Destina-
tion Gate In and Gate Out by material
between Source Gate In and Source Gate Out
by rippling the Destination material
Fit: Replaces material between Destination
Gate In and Gate Out by material between
Source Gate In and Source Gate Out by
stretching or squeezing the Source material