Editing : Source - Destination Editing
8 - 189
The Destination Gates currently selected for the next edit operation are displayed in Black.
The current Source and Destination Gates for the next edit operation are the selected group Gates or if no groups
are selected the last group where Gates have been set/removed/modified.
In 3 point editing, the “virtual” missing gate of the group that has only one gate set is displayed in Grey.
Set the Cursor to the selected Track Group Gate In/Out
Cursor & Marks > Cursor to Gate In/Out
Zoom to the selected Track Group Gate In/Out.
Cursor & Marks > Show Gate In/Out
Nudge the selected Track Group Gate In/Out with the menu selection
Cursor & Marks > Nudge Gates > Nudge Gate In/Out to Left/Right.
Each nudge operation can be auditioned automatically by setting
'Audition
after Nudge'
in the Settings > All Settings > Application > Editing page
Audition the selected
Track Group Gate In/Out Pre/Through/Post with the
menu selection:
Machines > Internal Machine > Audition > Audition Gate In/Out
Pre/Audition/Post
.
The space between
Gate In and Gate Out can be selected with the menu
Selection > Select between Gates.
Positions of
Gate In and Gate Out for each selected groups can be displayed and manually modified with the
Source-Destination Toolbar (If not already visible show with View > Scales > Toolbars > Source-Destination)
Once Gates In and Out have been set, Source - Destination operations can be applied FROM either the selected
Source Track Group or the last Source Track Group whose Gates have been set TO either the selected Destination
Track Group or the last Destination Track Group whose Gates have been set.
Both Source and Destination Gate In and Gate Out can be set or removed
(by setting them twice at the same position) to perform any combination of Source - Destination editing opera-
tion described in the table below.
When Gates are set the following Source-Destination operations available in the Edit menu (
Edit > Source-Desti-
nation > [edit command from list below]
can be applied:
• Auto-Edit Source to Destination
• Overwrite Source to Destination
• Insert Source to Destination
• Replace Source to Destination
• Fit Source to Destination
When the Source has only 1 Gate then the Region to edit can be automatically adjusted to the end (or beginning
in case of a single Gate Out) of the Clip under the Gate when the edit operation is performed. This is available by
choosing the menu item:
Edit > Source – Destination Settings > Limit 1 Gate Sources to End/Beginning of Clip.
When the Source has 2 Gates set and the Destination has 1 Gate set, then the behavior of the Auto-Edit Source to
Destination operation can be chosen between Overwrite or Insert by choosing the menu item:
Edit > Source- Destination Settings > 3 Gates Auto-Edit does Overwrite
or:
Edit > Source- Destination Settings > 3 Gates Auto-Edit does Insert
To Next Page
Loading...
