Recording and Acquisition : Digitizing Sessions
7 - 160
Autoconforming
1. Pyramix can record audio selectively according to an EDL (Edit Decision List) in the CMX format.
2. Follow the set-up suggestions above and ensure the source machine is working correctly under 9-pin control.
3. Click the Load EDL button, navigate to the directory containing the EDL you wish to load the audio for.
4. If the list is not already in Reel order, click the Optimize button. This will sort the list so that audio is digitized
with the minimum of reel changing and spooling. All overlapping edits will be merged.
5. Load the first reel in the list, click the Capture button and Pyramix will automatically control the source
machine. All the required audio in the reel will be digitized.
6. Change the reel when prompted until all the required audio has been digitized.
If you know the audio is not available for certain edits in the list, or you wish to digitize only certain edits, uncheck
the box(es) in the
Status field for the relevant entries before clicking Capture. The Status filed will show when
Clips have been captured which match the edits.
Enable All
Checks all the boxes in the Status Field for capture.
Disable All
Un-checks all the boxes in the Status Field. I.e. no edits are selected for capture.
Reset Status
Restores the Status Field check boxes to their previous state.
Export Report
Exports an .rtf file detailing the edits which were captured and those which were not.
Handles
Sets an extra amount of audio to be captured at each end of the edits. This allows greater freedom in editing but
may cause problems in some circumstances. The drop-down list gives a choice of from
0 to 10 frames.
To Next Page
Loading...
