Mixer : Audio Bridge
10 - 261
Once the Audio Bridge ASIO option is enabled in the VS3 Control Panel new sources and destinations will show up
in the Input and Output drop-down lists in the Pyramix Mixer/Monitor etc. just like any other source and destina-
tion. E.g.
Audio Bridge 1,2,3 etc.
Banks
are prefixed by the driver name, for example:
• Audio Bridge Bank 1
•ASIO4ALL Bank 1
Secondary Audio Device Host Mode
The Secondary Audio Device is either the built-in sound card or an external ASIO-type device. It is used as a Sec-
ondary Audio Device for Pyramix, in addition to the standard primary MassCore device or "Primary" ASIO card.
Application
This is used typically as a solution for monitoring the signal coming from a primary MassCore or ASIO based Horus
unit locally. Typically when the primary Horus unit deployed remotely as a stage box through RAVENNA.
Sine this Secondary Audio Device Hosting Mode is bi-directional it also provides talkback support for communica-
tion with a person located near the remote primary unit.
Note: The Secondary Audio Device should NOT be used to record from since it uses an always on
SRC to maintain perfect sync with the main unit without any external hardware based sync
being required. Recording should only be performed from signal coming from the primary unit.
The secondary unit should only be used for monitoring and talkback.
To Next Page
Loading...
