Automation : Dynamic Automation Levels
15 - 369
Selecting Automation Modes
Automation modes are set globally for the entire mixer, per strip or per component.
Entire Mixer
The entire mixer can be set to the same mode from the Automation menu or by right-clicking in a blank area of
mixer panel (E.g. under the bus strips) and selecting the desired mode from the popup menu.
Mixer > Automa-
tion > xxxxx
Block, Strip, Bus or Entire Mixer
Right-clicking in a mixer channel strip function-block, e.g. as shown here in the fader area, pops up a contextual
menu. Selecting
Automation opens a sub-menu offering a choice of four automation modes:
To Next Page
Loading...
