Automation : Filter Automation Tracks to Snapshot Dialog
15 - 382
Filter Automation Tracks to Snapshot Dialog Options
The top Tabs switch between displaying Controls by Strips or by Types of Control..
The bottom Tabs change the automatic selections :
All Every Control in the Mixer is selected
Nothing No Controls are selected
Displayed Only the Controls displayed on Tracks / Automation Sub-tracks are selected
Last The Control(s) selected previously are selected
Switches
Note: The following switches are only available when appropriate. E.g. Automation Snapshop
Cursor etc. not Delete Selected Points
Maintain to next point When ticked the parameter values at the cursor position will be maintained until
the next automation point per parameter.
To End When ticked the parameter values at the cursor position will be maintained until
the end of time(line).
Note: If both Maintain to next point and To End are ticked, then To End takes precedence.
To Next Page
Loading...
