Project Processes : Mixing Down Projects
17 - 406
appropriate export file type from the Media Format pop-up list, choose the bit depth/word length from the
Media Wordlength combo box.
Note: These settings are completely independent of the settings for Recording and Render.
5. In the Record section, choose to export the Whole composition, or the area between the In and Out Markers
with
Between Marks, or a Selection made previously, by clicking the appropriate radio button.
6. Processing choose Real time for a real-time mixdown otherwise, leave unchecked for a faster mixdown at
the same quality.
7. If the mixdown is required at a sampling rate other than the Project sampling rate check the SRC and ReDith-
ering
box. Clicking the 48ooo Hz/32bits/NoDither button opens the SRC Output Settings dialog.
8. Mix Sources - Choose the appropriate output bus(es) as the source for the exported file. All output buses con-
figured in your
Mixer will be available in the Bus Name list. Double-click the check boxes to add buses to the
mixdown. If the bus is a GP bus clicking in the
Channel Mapping column will pop-up a list of mapping
choices. Clicking in the
Destination Track column drops-down a list of all existing tracks in the Project plus
the options,
Create New Tracks and None.
Note: The names displayed will correspond to the labels in the mixer strips.
9. Mix Down begins the process.
Stop pops-up a Stop Record? confirm dialog. If you click Yes the recording stops at the point where you
clicked and is retained up to that point. The
Mix Down dialog is closed.
Abort pop-ups an Abort Record? confirm dialog. If you click Yes the recording is stopped at that point and
discarded. The
Mix Down dialog is closed.
Options
Processing
Real Time When checked the Mix Down will take place in Real Time
SRC and ReDithering When checked the settings shown in the button below come into play.
Clicking the button opens the SRC Output Settings Properties dialog.
Please
see: Properties... on page 70
Loudness and True peak Limiting
When checked Loudness control and True Peak Limiting will be applied to the mix-
down.
Note: One file per Bus/Stem mode must be enabled.
Settings Click on Settingsto open the Loudness and True peak limiting settings dialog:
True Peak Limiting Normalization Check the box to enable.
Target Loudness The drop-down list offers a choice of target loudness levels.
Max. True Peak The drop-down list offers a choice of maximum peak levels.
To Next Page
Loading...
