NEC Univerge SV9100 - Page 106

Issue 4.0
2-66 Program 10 : System Configuration Setup
12
Multicast Port
The port number that is used for
paging will change based upon the
following information.
The formula for the ports that will
be used is:
Starting port number assigned in
10-46-12 + Management ID * 2
The value of the Management ID
is from 1 to 64. The Management
ID will count up sequentially, for
example:
10-46-12 = 3000
The first page the system makes
will use port 30002 (3000 + 1*2).
The second page the system
makes will use port 30004 (3000 +
2*2).
The Management ID will
increment every time the page is
used. After the Management ID
reaches 64 it will start over, so the
next page will use Management ID
1.
The max. port starting from 3000
would be 30128 (3000 +64*2)
0~65535
30000
13
Subscribe Session Port
When using NetLink (Program 51-
01-01) this Program is not used
and Program 51-17-02 will be
used per each System ID.
0~65535
5081
14
NAT Mode
When the system controls the SIP
multiline terminal via the NAT
router, this system data is set to
On.
0 = Off
1 = On
0
Input Data (Continued)
Item
No.
Item Input Data Default
Related
Program