NEC Univerge SV9100 - Page 200

Issue 4.0
2-160 Program 14 : Trunk, Basic Setup
06
SMDR Printout
Include/Exclude the trunk you are
programming from the SMDR
printout. Refer to Program 35-01
and 35-02 for SMDR printout
options.
0 = No Print Out
1 = Prints Out
0 35-01
35-02
07
Outgoing Calls
Allow/Prevent outgoing calls on
the trunk you are programming.
0 = Deny (No)
1 = Allow (Yes)
1
08
Toll Restriction
Enable/Disable Toll Restriction
for the trunk. If enabled, the trunk
follows Toll Restriction
programming (example:
Programs 21-05, 21-06). If
disabled, the trunk is a toll free
line.
0 = Restriction Disabled (No)
1 = Restriction Enabled (Yes)
1 21-04
21-05
21-06
09
Private Line
0 = Disable Private Line (Normal)
1 = Enable Private Line (Private Line)
0
10
DTMF Tones for Outgoing
Calls
Enable/ Disable DTMF tones for
outgoing trunk calls.
0 = Disable (No)
1 = Enable (Yes)
0
11
Account Code Required
0 = Disable (No)
1 = Enable (Yes)
1
12
--- Not Used ---
13
Trunk-to-Trunk Transfer
Enable/Disable loop supervision
for the trunk. This option is
required for Call Forwarding
Off-Premise and Tandem
Trunking only.
0 = Disable (No)
1 = Enable (Yes)
1
14
Long Conversation Cutoff
Enable/Disable the Long
Conversation Cutoff feature for
each trunk.
0 = Disable (No)
1 = Enable (Yes)
0 20-21-03
20-21-04
15
Long Conversation Alarm
Before Cutoff
Enable/Disable the Long
Conversation Alarm for each
trunk.
0 = Disable (No)
1 = Enable (Yes)
0 20-21-01
20-21-02
Item
No.
Item Input Data Default
Related
Program