NEC Univerge SV9100 - Page 227

Issue 4.0
SV9100 Programming Manual 2-187
03
Extension Ring Tone
Set the tone (pitch) of the incoming
extension call ring for the extension
port you are programming. Also
refer to Program 15-08.
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
8
04
Redial (Speed Dial) Control
Control the function of the
extension Redial key when used
with Speed Dialing. The Redial key
can access either the Common or
Group Speed Dialing numbers.
0 = Common and Individual Speed Dialing
1 = Group Speed Dialing
0
05
Transfer Key Operation Mode
Set the operating mode of the
extension CONF key. The keys can
be for Call Transfer, Serial Calling
or Flash. When selecting the Flash
option (selection 2), refer also to
Program 81-01-14.
0 = Transfer
1 = Call back
2 = Hook
0
06
Hold Key Operating Mode
Set the function of the Multiline
Hold key. The Hold key can
activate normal Hold or Exclusive
Hold.
0 = Normal (Common)
1 = Exclusive Hold
0
07
Automatic Hold for CO Lines
When talking on a CO call and
another CO line key is pressed, the
original trunk is placed on Hold or
Disconnected.
0 = Hold
1 = Disconnect (Cut)
1
08
Automatic Handsfree
Set whether pressing a key
accesses a One-Touch Key or if it
preselects the key.
0 = Preselect
1 = One-Touch (Automatic Handsfree)
1
10
Ringing Line Preference for
Trunk Calls
Select between Idle and Ringing
Line Preference for trunk calls.
0 = Idle (Off)
1 = Ringing (On)
1
Item
No.
Item Input Data Default
Related
Program