Issue 4.0
2-12 Program 10 : System Configuration Setup
03
--- Not Used ---
04
Layer 3 Timer Type
Each timer value of Layer 3
is set up for each type in
Program 81-06 (T-Bus)
1~5
1
05
CLIP Information
Based on this setting, the system
includes a Presentation Allowed (1) or
Presentation Restricted (0) in the Setup
message to allow or deny the Calling
Party Number. Program 15-01-04 must
also be set to 1 if this option is enabled.
0 = Disable
1 = Enable
1
06
Length of Cable
0 = Level 1 (0~40m)
1 = Level 2 (40~81m)
2 = Level 3 (81~122m)
3 = Level 4 (122~162m)
4 = Level 5 (162~200m)
2
07
--- Not Used ---
08
Dial Sending Mode
ISDN Protocol definition
0 = Enbloc Sending
1 = Overlap Sending
0
09
Dial Information Element
ISDN Protocol definition (Only when
Dialing Sending Mode (10-03-08) is set
for 1 (Overlap Sending)
0 = Keypad Facility
1 = Called Party Number
0
10
Master/Slave System
If set to 0, system is synchronized to the
network clock. If set to 1, system is not
synchronized to the network clock. (For
NW Mode)
0 = Slave System
1 = Master System
0
11
Networking System No. (for NW
Mode)
0~50
0
13
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up.
0 = Level 0 (lowest sensitivity)
1 = Level 1
2 = Level 2
3 = Level 3
4 = Level 4
5 = Level 5
6 = Level 6
7 = Level 7 (highest sensitivity)
2
14
--- Not Used ---
15
--- Not Used ---
Item
No.
Item Input Data Default
To Next Page
Loading...
