NEC Univerge SV9100 - Page 871

Issue 4.0
SV9100 Programming Manual 2-831
57 2 0 IP Collision
Error
Collision(01) indicates the
address programmed in
10-12-01 has been
duplicated. Collision (02)
indicates the address
programmed in 10-12-09
has been duplicated.
Collision(03) ~
Collision(10) indicates the
addresses programmed in
84-26-01 have been
duplicated. (03) is GW1 ~
(10) is GW8.
An IP address
programmed in
either 10-12-01, 10-
12-09 or 84-26 is
duplicated
somewhere on the
same segment of
the network. The
system will check
every 5 minutes
and is not a
programmable
increment.
Confirm that the
addresses assigned in
10-12-01, 10-12-09,
and 86-26 are not
duplicated anywhere
else on the network.
58 2 0 Failure of
Outbound IP
Connection
01: Programming session
is already active.
02: Not setting of IP
Address or Port.
03: Caller ID does not
match.
10: Cannot get IP Address.
11: Socket Open Error.
12: Socket Port Setting
Error.
13: TCP Session Timeout.
59 --- Reserved ---
60 2 0SIP
Registration
Error
Notification.
1.The registration of the
SIP trunk to the SIP
server failed.
2.The registration of the
SIP trunk to the SIP
server failed in the
authentication.
3.There is no response
from the SIP server to
the SIP registration
request.
1. The system data
setting is wrong.
2. The router
setting is wrong.
3. LAN link error.
4. Net side trouble.
1. Confirm the following
system data setting --
PRG 10-12, 10-28,
10-29, 10-30, and 10-
36.
2.Confirm the setting of
routers.
3.Confirm whether
abnormality occurs
on the net side.
4. Confirm the
authentication
system data setting.
5. Confirm wiring and
the system data
setting. Inquire on
uncertain points of
the maker.
The error is
recovered
when normally
connecting it.
ERR
REC
Alarm
No.
Type Report Name Content of Alarm Cause Action Recovery
Alarm
Status