NEC Univerge SV9100 - Page 872

Issue 4.0
2-832 Program 90 : Maintenance Program
61 0 0 SIP extension
trouble
information.
1. Failed registration of the
SIP extension terminal.
2. The SIP extension
terminal DSP was not
acquired:
• At registration of SIP
extension terminal to
SV9100.
• When you cannot
acquire the DSP
resource when it is
sent.
1. The registered
port is used by
other extension.
2. The license is
insufficient.
3. DSP of VoIPDB
not acquired.
1. Confirm wiring and
system data setting.
2. Confirm whether
each equipment
such as access
points works
normally.
ERR
REC
62 --- Reserved ---
63 0 0SIP-MLT
trouble
information.
1. The trouble occurred in
the SIP-MLT relation.
2. The DSP resource could
not be acquired at
incoming/outgoing.
3. The negotiation with
VoIPDB failed.
1. The packet loss
occurred on the
network or the
wiring cutting
occurred.
2. DSP of VoIP not
acquired.
Confirm whether each
equipment such as
wirings and HUB is
normal.
WAR
64 1 0 VoIPDB LAN
Link Error.
The link of LAN of VoIPDB
came off.
1. LAN cable
defective.
2. Connected HUB
broken.
3. Defective
GCD-CP10.
1. Confirm LAN
connector and
wiring.
2. Check with maker on
uncertain points.
When the
connection
returns
normally, the
error is
recovered.
ERR
REC
65 0 0 VoIPDB
trouble
information.
When DSP of VoIPDB
notifies Error.
GPZ-IPLE
defective.
1. Possibility of
defective hardware.
2. Check with maker on
uncertain points.
WAR
66 2 0 SIP extension
License Error.
More than the number of
licenses to which the SIP
extension terminal was
turned on at REGISTER.
Wrong number of
licenses.
1. Confirm number of
licenses for SIP
extension terminals.
2. Check with maker on
uncertain points.
When the
number of
registration of
SIP extension
terminals falls
below the
number of
licenses.
WAR
67 0 0 SIP illegal
packet
received.
The system received an
illegal packet.
A client or network
is in an illegal state.
Check with maker on
uncertain points.
INF
68 2 0 VoIP DSP All
Busy Alarm
1. Provides alert when all
DSP resources are being
used.
2. Used to troubleshoot or
alerting when upgrade is
needed.
Not enough DSP
resources in
system.
Install PZ-VMDB with
more DSP resources.
69 --- Reserved ---
Alarm
No.
Type Report Name Content of Alarm Cause Action Recovery
Alarm
Status