309-00-6 Exhaust System — General Information 309-00-6
REMOVAL AND INSTALLATION (CONTINUED)
6. Remove the bottom rear shock absorber
mountings (Refer to Section 204-02) and
lower the rear axle to allow the removal of the
center and rear muffler.
7. Disconnect the exhaust system from the
downpipe and remove the exhaust system.
Installation
1. Install components in reverse order.
Note: Petrol engine - Renew ring seal and
exhaust springs.
Diesel engine - Renew ring gasket and exhaust
pipe flange gaskets.
E5946 EN 07/2001 2002 Bantam
To Next Page
Loading...
