501-11-21 Glass, Frames and Mechanisms 501-11-21
REMOVAL AND INSTALLATION
Front Door Window Regulator and Motor (42 338 0)
Removal
1. Remove the front door trim panel. For
additional i
nformation, refer to Section 501-
05.
2.
CAUTION: Do not touch the adhesive
surface, as re-bonding will be
impaired.
Detach the door panel watershield.
3. Connect the window control switch
electrical connector.
4. Remove the window glass retaining screws.
• Align the retaining screws with the
access hole.
5. Detach the window glass from the window
regulator.
6.
CAUTION: Make sure the window
glass is adequately supported at the
top of the opening.
Using suitable hooks, raise and secure the
window glass.
E6781 EN 08/2001 2002 Bantam
FORD BANTAM
TO MODEL INDEX
PAGES FROM MANUAL
BACK TO CHAPTER INDEX
To Next Page
Loading...
