211-05-103 Steering Column Switches 211-05-103
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the voltage between the ignition relay
C47 pin 3, circuit 30 (RD) and ground.
• Is the voltage greater than 10 volts?
Yes
GO TO C7
No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
C7: CHECK FOR OPEN ON CIRCUIT 15 (GN)
1.
Fuse 17 (15A)
2 Measure the resistance between ignition relay
C47 pin 5, circuit 15 (GN) and supply side of
Fuse F17 (15A).
• Is the resistance less than 5 ohms?
Yes
INSTALL a new ignition relay. TEST the
system for normal operation.
No
REPAIR circuit 15 (GN). TEST the system
for normal operation.
PINPOINT TEST D: NO POWER IN START
CONDITIONS
DETAILS/RESULTS/ACTIONS
D1: CHECK FUSE 36 (60A)
1.
Fuse 36 (60A)
E1227 EN 07/2001 2002 Bantam
To Next Page
Loading...
