501-16-28 Wipers and Washers 501-16-28
REMOVAL AND INSTALLATION
Windshield Wiper Motor (32 524 0)
Removal
1. Standard preparatory measures
• Note the radio keycode.
• Note the pre-set radio stations.
CAUTION: Disconnect the battery nega-
tive lead.
2. NOTE: The wiper motor must be in the park
position.
Remove the wiper arms.
• Unclip the cover.
• Undo the nuts two turns.
• Lift the wiper arms and release them
from the taper by moving them from side
to side.
• Unscrew the nuts and remove the wiper
arms.
• Unscrew the nuts from the pivot shaft
bearings.
3. Detach the coolant recovery tank.
• Remove the bolt.
• Pull it out and lay it to one side.
4. Remove the bulkhead cover.
• Remove the rubber sealing strip.
• Unclip the central junction box (CJB)
cover.
• Unscrew the bolt.
E921 EN 07/2001 2002 Bantam
To Next Page
Loading...
