419-01B-11 Anti-Theft — Passive 419-01B-11
REMOVAL AND INSTALLATION
E6378 EN 07/2001 2002 Bantam
Passive Anti-Theft System (PATS) Module
NOTE: The immobiliser (PATS) functionality for
petrol engine variants with manual transmission is
incorporated in the powertrain control module.
NOTE: When fitting a new immobiliser (PATS)
module the new module must be coded to the im-
mobiliser system. To code the system two valid
keys must be available before fitting a new module.
NOTE: If two valid keys are not available it will be
necessary to code the system using WDS.
Removal
1. Disconnect the battery ground cable.
2. Remove the left hand side cowl side trim
panel, for further information
refer to Section 501-05.
3. Detach the Powertrain Control Module
(PCM) for further information
refer to Section 303-14.
4. Disconnect the multiplug and remove the
PCM module.
Installation
1. Refit the components in reverse order.
To Next Page
Loading...
