Ford 2002 Bantam - Accelerator Cable Adjustment - Vehicles with Diesel Engine (23 811 0)

310-02-59 Acceleration Control 310-02-59
GENERAL PROCEDURES (CONTINUED)
E5955 EN 09/2001 2002 Bantam
Accelerator Cable Adjustment — Vehicles with Diesel Engine (23 811 0)
1. Remove the accelerator cable retaining clip.
2. Pull the accelerator cable adjuster through
the grommet until the grommet is at the end
of the accelerator cable adjuster.
3. Depress the accelerator pedal to the floor
stop and hold.
4. Install the accelerator cable retaining clip.
5. Depress the accelerator pedal to the floor
stop to make sure that full travel is achieved
at the throttle body and release the
accelerator pedal to make sure that the
throttle plate returns to the fully closed
position.