417-01-74 Exterior Lighting 417-01-74
REMOVAL AND INSTALLATION
Rear Lamp Assembly (32 305 0)
Removal
1. Remove the rear lamp assembly retaining
screws and the electrical connector (Right
hand side shown).
1. Screw.
2. Rear lamp.
3. Rear lamp electrical connector.
2. Unclip the lens cover.
• Push the hook up using your fingers.
4.
Remove the bulbs (bayonet fit).
1 Screw
2 Lens
3 Rear turn light bulb
4 Reverse light bulb
5 Brake / taillight bulb.
Installation
NOTE: Ensure the seal is seated correctly to
prevent water ingress.
1. To install, reverse the removal procedure.
E6757 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL
To Next Page
Loading...
