Ford 2002 Bantam - The Engine Cranks Slowly

303-06-208 Starting System 303-06-208
DIAGNOSIS AND TESTING (CONTINUED)
E1017 EN 09/2001 2002 Bantam
A15: CHECK CIRCUIT 30 (RD) FOR SHORT TO GROUND
1 Remove fuse 36 (60A).
2 Measure the resistance between fuse 36
connector pin 1, circuit 30 (RD) and ground.
• Is the resistance greater than 10,000 ohms?
 Yes
GO TO A16
 No
REPAIR circuit 30 (RD). TEST the system
for normal operation.
A16: CHECK CIRCUIT 50 FOR SHORT TO GROUND
1.
Ignition switch
2 Measure the resistance between the ignition
switch connector pin 3, citcuit 50 (GY) and
ground.
• Is the resistance greater than 10,000 ohms?
 Yes
CONNECT the ignition switch.
GO TO A8
 No
REPAIR circuit 50 (GY). TEST the system
for normal operation.
PINPOINT TEST B: THE ENGINE CRANKS SLOWLY
CONDITIONS DETAILS/RESULTS/ACTIONS
B1: CHECK THE BATTERY VOLTAGE
1 Measure the voltage between the battery
terminals.
• Is the voltage greater than 12.5 volts?
 Yes
GO TO
B2
 No
CHARGE or INSTALL a new battery as re-
quired.
REFER to Section 414-00.
TEST the system for normal operation.