Ford 2002 Bantam - Headlamp Adjustment

417-01-75 Exterior Lighting 417-01-75
GENERAL PROCEDURES
Headlamp Adjustment
General Equipment
Headlamp beam setting equipment
Adjustment
1. Before starting the headlamp adjustment:
• Place the vehicle on a level surface.
• Check the correct headlamp operation,
and renew damaged components as
necessary.
• Check the tyre inflation.
• Check that no other load is in the vehicle
other than a half tank of gas.
• Set the measuring screen of the beam
setting equipment to the following
headlamp adjustment value (X): X=10
cm/10 m=0 degrees 34 minutes=1.0%.
2. Adjust the low beam.
• Switch on the low beam.
1. Vertical alignment screw.
2. Horizontal alignment screw.
3. Vertical adjustment.
• Adjust the low beam so that the
light/dark boundary touches the horizontal
line.
E6758 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL