Ford 2002 Bantam - Hazard Lamps Are Inoperative or on Continuously

417-01-47 Exterior Lighting 417-01-47
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the voltage between rear turn signal
lamp, right-hand side, connector C66, circuit
49-LG19 (BU/RD), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
GO TO L20
 No
REPAIR the open circuit(s) between splice
S35 and rear turn signal lamp, right-hand
side, by using the wiring diagrams. TEST
the system for normal operation.
L20: CHECK THE GROUND CONNECTION OF REAR TURN SIGNAL LAMP, RIGHT-HAND SIDE
1 Measure the resistance between rear turn
signal lamp, right-hand side, connector C66,
circuit 31-LG19 (BK), harness side and ground.
• Is the resistance less than 2 ohms?
 Yes
CHECK the rear turn signal lamp, right-hand
side. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between rear
turn signal lamp, right-hand side and ground
G3, by using the wiring diagrams. TEST the
system for normal operation.
PINPOINT TEST M: HAZARD LAMPS ARE INOPERATIVE OR ON CONTINUOUSLY
CONDITIONS DETAILS/RESULTS/ACTIONS
M1: DETERMINE THE FAULT CONDITION
1.
2 Actuate the hazard warning switch.
• Are the hazard warning lamps inoperative?
 Yes
GO TO M2
 No
The hazard warning lamps are on continu-
ously: GO TO M8
E9426 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL