308-03-109 Manual Transaxle 308-03-109
GENERAL PROCEDURES
E3570 EN 07/2001
Bearing Check
1. NOTE: Use the following procedure when
checking taper roller bearings and roller
bearings:
General notes.
• Check the condition of all the
components when disassembling them.
• Find out the cause of the damage with
the aid of the following illustrations.
• Remedy the problem and, if necessary,
renew the bearing
(see bearing checks).
2. Bearing cage damaged at the top or side
through incorrect use of a special tool or
use of the wrong tool.
• Renew the bearing.
3. The taper roller ends are discolored as a
result of inadequate lubrication, overheating
or excessive bearing preload.
• Renew the bearings and gaskets and
make sure there is adequate lubrication.
4. Taper roller ends are worn away as a result
of incorrect installation, excessive bearing
preload or incorrect seating.
• Renew the bearings and gaskets and
make sure there is adequate lubrication.
To Next Page
Loading...
