Ford 2002 Bantam - The Reversing Lamp Is Inoperative

417-01-61 Exterior Lighting 417-01-61
DIAGNOSIS AND TESTING
Reversing Lamps
Inspection and Verification
1. Verify the customer concern.
2. Visually inspect for obvious signs of
mechanical or electrical damage.
Visual Inspection Chart
Electrical
• Fuse(s).
• Bulb(s).
• Wiring harness.
• Electrical connector(s).
3. If an obvious cause for an observed or
reported concern is found, correct the cause
(if possible) before proceeding to the next
step.
4. If the cause is not visually evident, verify the
symptom and refer to the Symptom Chart.
Symptom Chart
Symptom Chart
Condition Possible Sources Action
• The reversing lamp is inopera-
tive.
• Fuse.
• Circuit(s).
• Reversing lamp.
• Transmission switch.
• Go To Pinpoint Test Q
• The reversing lamp is on con-
tinuously.
• Circuit(s).
• Transmission switch.
• Go To Pinpoint Test R
Pinpoint Tests
PINPOINT TEST Q: THE REVERSING LAMP IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
Q1: CHECK THE FUSE F13
1. 2.
Fuse F13 (CJB)
3 Check the fuse F13 (15 A).
• Is the fuse OK?
 Yes
GO TO Q2
 No
INSTALL a new fuse F13 (15 A). If the fuse
blows again, LOCATE and REPAIR the
short circuit by using the wiring diagrams.
TEST the system for normal operation.
E6755 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL