Ford 2002 Bantam - Page 1384

417-01-60 Exterior Lighting 417-01-60
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
2 Measure the voltage between fuse F15 (5 A)
and ground.
• Is battery voltage indicated?
 Yes
REPAIR the open circuit(s) between fuse
F15 and multifunction switch, by using the
wiring diagrams. TEST the system for
normal operation.
 No
REPAIR the power supply of fuse F15, by
using the wiring diagrams. TEST the system
for normal operation.
P4: CHECK THE POWER SUPPLY OF FUSE (S) F6 AND F7
1 Measure the resistance between multifunction
switch, connector C15a, pin 7, circuit 29S-DB7
(OG/YE), harness side and fuse F6 (5 A) or
fuse F7 (5A).
• Is the resistance less than 2 ohms?
 Yes
CHECK the multifunction switch, according
to Component Testing attached to the wiring
diagrams. If necessary INSTALL a new one.
TEST the system for normal operation.
 No
REPAIR the open circuit(s) between multi-
function switch and fuse(s) F6 and F7, by
using the wiring diagrams. TEST the system
for normal operation.
E9427 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL