Ford 2002 Bantam - Brake Fluid Reservoir (12 341 0)

206-06-8 Hydraulic Brake Actuation 206-06-8
REMOVAL AND INSTALLATION
E9399 EN 03/2001 2002 Bantam
Brake Fluid Reservoir (12 341 0)
Removal
CAUTION: If brake fluid is spilt on the
paintwork the affected area must be
immediately washed down with cold wa-
ter.
1. Disconnect the low brake fluid warning
indicator switch electrical connector.
2.
CAUTION: The brake fluid reservoir
cap must not become contaminated.
Remove the brake fluid reservoir cap.
3. NOTE: It will be necessary to carry out this
step on both sides in order to completely
drain the brake fluid reservoir.
Drain the brake fluid reservoir.
1. Connect one end of a suitable piece of
clear plastic pipe to the bleed nipple and
place the other end into a suitable
container.
2. Loosen the bleed nipple.
3. Depress the brake pedal until all of the
brake fluid is drained from the brake fluid
reservoir.
4. Tighten the bleed nipple.
4.
CAUTION: Cap the clutch master
cylinder hose to prevent fluid loss or
dirt ingress.
Disconnect the clutch master cylinder hose
from the brake fluid reservoir.