204-02-13 Rear Suspension 204-02-13
REMOVAL AND INSTALLATION
E6585 EN 06/2001 2002 Bantam
Bump Rubber (15 413 4)
Removal
1.Jack up the rear of the vehicle, fit stands
under the body and chock the front wheels.
For additional information,
refer to Section 100-02
NOTE: It is essential that the vehicle does not
exceed the maximum kerb weight if it is to be
raised and supported on the axle tube.
2. Remove bolt securing the bump rubber to
axle mounting plate.
3. Remove the bump stop.
To Next Page
Loading...
