Ford 2002 Bantam - The Tachometer Is Inoperative

413-01-13 Instrument Cluster 413-01-13
DIAGNOSIS AND TESTING (CONTINUED)
CONDITIONS
DETAILS/RESULTS/ACTIONS
C3: TEST OPERATION OF THE ENGINE COOLANT TEMPERATURE SENSOR
1 Select the instrument cluster self-diagnostic
mode test 11 – engine coolant temperature
signal input.
- Check the input when the engine is cold and
then when the engine is warm.
• Is there an input from the engine coolant
temperature sensor?
 Yes
USE WDS to diagnose the PCM and the
ISO link.
 No
INSTALL a new engine coolant temperature
sensor. TEST the system for normal opera-
tion.
PINPOINT TEST D: THE TACHOMETER IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
D1: TEST OPERATION OF THE TACHOMETER
1 Select the instrument cluster self-diagnostic
mode test 1 – gauge sweep.
• Does the tachometer carry out a gauge
sweep?
 Yes
GO TO D2
 No
INSTALL a new instrument cluster. TEST
the system for normal operation.
D2: RETRIEVE ANY STORED DTCS
1 Select the instrument cluster self-diagnostic
mode test 6 – list DTCs stored.
• Are there any stored DTCs?
 Yes
REFER to the Instrument Cluster DTC
Index.
 No
USE WDS to diagnose the PCM and the
ISO link.
PINPOINT TEST E: THE HIGH BEAM INDICATOR IS INOPERATIVE
CONDITIONS DETAILS/RESULTS/ACTIONS
E1: CHECK OPERATION OF HIGH BEAM
1.
E1282 EN 09/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM PAGES FROM MANUAL
TO MODEL INDEX
CONTINUED